Freezing default motion/sound (or behavior?)

[PleoMiami]

I have some .wav and .umf files loaded onto an SD card in my Pleo, which I trigger using the pleo monitor, but I've been having some issues with the motions being interrupted or not playing correctly. I assume this is because Pleo's default behavior does not recognize that I've triggered a custom motion and goes ahead playing its own. Is there any way to prevent Pleo from interrupting my motion commands? For now, I'm switching between a blank personality and the default personality with app load/unload - very slow.

To deal with sounds, is there any way to effectively stop the currently playing sound? I noticed there is a "motion stop" command, but none for sound.

[UgobeBarsha]

I have some .wav and .umf files loaded onto an SD card in my Pleo, which I trigger using the pleo monitor, but I've been having some issues with the motions being interrupted or not playing correctly. I assume this is because Pleo's default behavior does not recognize that I've triggered a custom motion and goes ahead playing its own. Is there any way to prevent Pleo from interrupting my motion commands? For now, I'm switching between a blank personality and the default personality with app load/unload - very slow.

To deal with sounds, is there any way to effectively stop the currently playing sound? I noticed there is a "motion stop" command, but none for sound.

Hi PleoMiami,
It is not possible to prevent Pleo's default personality from interrupting your motion commands until its default personality has been completely unloaded. And, also make sure that your current drive is A from where you will run your commands. Use command “chdrv a" to change your drive to A. Then, you should be able to run motion command without interruption.
For sound, you can decrease its volume to 0 which would be equivalent to mute.
Hope this helps. Keep us updating. :)